CareTech Gloria User's Guide download pdf (Page 17)

Programming

The carephone’s telephone numbers, alarm codes and settings are

programmed via a computer, using the programming cable and the

CareTech CS software.

For help with programming and information about other programming tools,

please refer to the carephone’s technical handbook or contact your supplier.

In some cases, the carephone can be delivered ready-programmed by the

supplier.

Programming radio triggers

Up to nine radio triggers or other radio-alarm transmitters, e.g. smoke

detectors, can be programmed for the carephone.

Programming radio transmitters:

• Hold down the green button for approximately four seconds until the

green “On” light starts to flash.

• Press the radio trigger. Once the carephone has received the radio

signal, you will hear a distinct tone signal.

• Confirm by pressing the red button on the carephone.

Check radio coverage

This should always be done on installation.

• Hold down the green button for approximately four seconds until the

green “On” light starts to flash.

• Press the radio trigger. The built-in speaker will produce a tone

signal on successful reception. Repeat this in all areas where the

alarm needs to operate.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

CareTech Gloria User's Guide Page 17